740 L4-2320cc 2.3L DOHC B234F (Can) (1992)
Remove:
- bolts attaching balance shaft housing to cylinder block.
Place container underneath joint (or place paper on front crossmember) to collect oil spillage from housing.
Remove balance shaft housing
Use extractor 5376.
Position tool over rear mounting point.
Separate housing from cylinder block carefully. Use tool (e.g. 5196) simultaneously to prise loose front mounting to assist in removing housing.
CAUTION: If housing is to be reused, it must be removed evenly from front and rear mountings.
Clean mounting points
Clean joint faces on cylinder block.
Place 0-rings in position
Place 0-rings in grooves around housing oilways. Fix 0-rings in position by packing grooves with grease and lubricate housing joint faces with thin
coating of grease.