740 L4-2320cc 2.3L DOHC B234F (Can) (1992)
Remove timing/balance shaft drive pulleys
Remove timing belt outer guide, pulley and inner guide.
Remove balance shaft pulley.
Remove seal
Prise out seal carefully using screwdriver, taking care to avoid damaging sealing faces on shaft and in seating flange.
Clean crankshaft end and seating flange. Inspect shaft for signs of wear.
Fit new seal
Use tool 5263.
Grease seal.
Place seal on tool.
Tap seal home into seating flange.
NOTE: Face of seal should normally be flush with chamfered edge in housing. However, if shaft end shows signs of wear, seal may be located approx.
3 mm further in.
Install balance shaft drive pulley