740 L4-2320cc 2.3L DOHC B234F (Can) (1992)
Tighten center bolt to 50 Nm (37 ft.lb). Use tool 5362 as counterhold.
Check axial clearance of balance shaft
Measure clearance using dial gauge mounted on magnetic stand.
Axial clearance 0.06-0.19 mm (0.0024-0.0075 in)
Install alternator and servo pump bracket
Check alternator and servo pump connections.
Reattach support under intake manifold.
NOTE: Remember to attach cable tie (clamp) to bottom bolt on support.
Install:
- air mass meter with air inlet hose and connections
NOTE: Lower engine if unit has been raised to provide access to right-hand balance shaft housing.