740 L4-2320cc 2.3L DOHC B234F (Can) (1992)
-
Connect battery lead and start car.
-
Turn A/C system on so the compressor starts.
The A/C system starts if the temperature exceeds approx. 7°C (45 °F).
-
Make up a cable approx. 2 meters (6.5 ft) in length to connect battery positive terminal to the connector on the control module. Connect to green
cable, connector terminal 6, for at least 30 seconds while compressor is working.
-
Turn off engine.
Airing cycle should begin after approx. 10 seconds and continue for approx. 1 second.
-
Remove cable between connector and battery.
-
Replace all parts removed.
-
Enter radio code if anti-theft coded radio installed.
A15
Information to Car Owner
-
Carry out operations at the end of this service bulletin.
740/940 With MCC Model Year 1991-95
Installation of control module and cables.
740/940 with MCC model year 1991-95
B1
Preparations
-
Clean evaporator according to:
Service Bulletin 8-87-948
-
Make note of radio code if anti-theft coded radio installed
Remove:
-
Negative battery lead
-
Sound insulation on passenger side
-
Glove compartment
-
Cowl on passenger side
-
Ashtray
-
Cigar lighter
-
Storage compartment
-
Detach pull central electronics module out.
Refer to Service Manual
Section 3(35-39), Lighting instrumentation and other electrical equipment
700/900 1982- (see Group 37)
TP 3562201
Section 8 (82-86, 88), Interior, exterior
7001900 1982-
TP8202201
B2