740 L4-2320cc 2.3L DOHC B234F (Can) (1992)
-
Connect battery lead and start car.
-
Turn A/C system on so the compressor starts.
The A/C system starts it the temperature exceeds approx 7°C (450°F)
-
Make up a cable approx 2 meters (6.5 ft) in length to connect battery positive terminal to the connector on the control module. Connect to green
cable, connector terminal 6, for at least 30 seconds while compressor is working.
-
Turn off engine.
Airing cycle should begin after approx. 10 seconds and continue for approx 1 second.
-
Remove cable between connector and battery.
-
Replace all parts removed.
-
Enter radio code if anti-theft coded radio installed.
B13
Information to Car Owner
-
Carry out operations at the end of this service bulletin.
760/940SE/960 ECC Model Year 1988-94
Installation of control module and cables. 760/940SE/960 ECC model year 1988-94
D1
Preparations
-
Clean evaporator according to:
Service Bulletin 8-87-948.
-
Make note of radio code if anti-theft coded radio installed.
Remove:
-
Negative battery lead.
Sound insulation on left and right sides.
-
Glove compartment.
-
Cowl on passenger side.
Refer to Service Manual:
Section 8 (82-86. 88), Interior, exterior
700/900 1982-
TP 8202201
Cable connections
D2
Installing new relay on cable harness
-
Select the cable harness (P/N 9148758) supplied with kit.