740 L4-2320cc 2.3L DOHC B234F (Can) (1992)
-
Route green cables with single round or flat terminals to engine compartment through unused outlet in grommet under brace to suspension strut
(tower).
-
Connect round or flat connectors to corresponding existing connectors.
-
Connect unconnected connectors together.
E4
Location of opening in cable sheath
The cable sheath is cut to drain off condensation.
-
The cut conduit section should be placed at the lowest point in the cable routing.
Use bury tape to seal the grommet.
-
Use existing clamps to clamp up the cables to firewall.
E5
Connection of yellow connector
-
Disconnect the yellow connector from the heater and attach the yellow connector from the new cable harness.
-
Connect the detached yellow connector to the yellow connector on the cable harness
Installation of control module from kit.
E6
Connection and mounting of control module