740 L4-2320cc 2.3L DOHC B234F (Can) (1992)
13. Fit the spider in the propeller shaft yoke. Insert the spider in the yoke and fit the bearing cups, one at a time as previously described.
14. Check the universal joint. If the joint is stiff or binds, place the propeller shaft yoke or flange yoke on the vice as illustrated and lightly tap the
ends with a plastic mallet or copper hammer.
15. Put the propeller shaft together.
-
Grease the splines with grease P/N 1161033-4.
-
Make sure that the rubber seal for the splines shaft is not damaged.
CAUTION: Make sure that the marks coincide and that the yokes on the front Section are in the same position. Angular misalignment between
the yokes will cause vibration.
16. Install the propeller shaft.Secure it with one bolt in each end. Fit the center support bearing and bracket. Attach the center Support bearing loosely
at the bracket. Fit all flange bolts (5244). center the bearing and tighten.