740 L4-2320cc 2.3L DOHC B234F (Can) (1992)
7. Fit the gear lever knob. Remove any old adhesive remaining on the lever and in the knob. Apply a bead of thread sealing compound P/N 1161
075-5. Press the knob into place. Remove any excess compound.
8. Fit the gear lever.
M46: Secure the wire used earlier to the overdrive cables. Apply a small amount of rubber bush compound P/N 1161153-0 to the bottom end
of the gear lever. Assemble the two parts of the gear lever.
M46: Thread through the overdrive cable at the same time. Don't stretch the cable too tight. Fit the tubular pin.
9. M46: Assemble the electrical components for operating the overdrive.
Assemble:
-
the pin in the connector on the right-hand side
-
the connector
-
the overdrive switch
Check the operation of the overdrive. Fit the ashtray.