760 L4-2320cc 2.3L SOHC Turbo B23FT (1984)
Exterior Moulding / Trim: By Symptom
Interior - Wind Noise
SECTION
GROUP
NO.
80
1
DATE
JUNE, 1984
RE:
WIND NOISE
760 GLE
THIS BULLETIN IS APPLICABLE TO THE U.S. AND CANADIAN MARKETS, AND SUPERCEDES SERVICE BULLETIN GROUP 80 NO. 1
ISSUED JULY, 1983.
If complaints of wind noise are received, the level of noise can be reduced, by performing the following procedures:
DOOR ADJUSTMENTS
Ensure that the clearance between the B-pillar and the outside of the front door does not exceed 10.5 mm (0.40")
Take the measurement at a point approximately 10 cm (4") from the top of B-pillar.
The rear door should be 0-1.5 mm (0.60 further in than the front doors.
ADJUSTING FRONT DOORS
Adjust position of door by moving the striker plate sideways. If further adjustment is necessary, slacken the upper door hinge bolts. (Do not slacken more
than 3 bolts at a time or door may drop). Press door in towards body.
Adjust rear doors.
Slacken the door hinge bolts and adjust as required. (No more than 3 bolts at a time.)