760 L6-2383cc 2.4L DSL Turbo D24T (1983)
29. Assemble rear and front housings.
NOTE: Make sure gasket fitted between brake drum and rear housing is installed.
Remove remains of old nylon washers from two upper bolts on rear housing. Install new nylon washers, small end towards rear housing. Torque
nuts in stages to 12 Nm (9 ft ft lb).
30. Install bridges. Torque nuts to 10 Nm (7 ft lb).
31. Install solenoid. Attach ground wire. Use crow-foot wrench P/N 5172. Torque to 50 Nm (37 ft lb).
Installation
1. Fit the overdrive on the transmission output shaft and install the nuts.
NOTE: If the drive flange has been removed install with tool P/N 1845.
2. Install transmission crossmember assembly.
3. Connect wires at the solenoid.
4. Connect propeller shaft.
5. Fill oil, ATF type G (or F).
6. Test drive the vehicle to check function of overdrive.
7. Check oil level.
Replacing Oil Seal at Output Shaft
1. Disconnect propeller shaft at overdrive. Use tool P/N 5244.
2. Remove drive flange nut. Use wrench P/N 5149 to hold.
3. Use puller P/N 2261 to remove drive flange