760 V6-2849cc 2.8L SOHC B28F (1983)
L2. Remove brake pads
Remove lower bolt and raise piston housing.
L3. Remove
^
brake caliper. Use 10 mm Allen key. Place caliper on support arm, taking care to avoid damage to brake hoses.
^
guide pin
^
brake disc
L4. Check that hub flange is clean. Remove grit, oxidation, etc. with scraper blade and steel brush
If hub is marked as described in L9, proceed to operations L11-L16.
If hub is not marked, carry out operations L5-L16.
L5. Remove grease cup and split pin
Tighten castellated hub nut to 10 Nm (7.5 ft. lbs.).
Purpose is to eliminate bearing play which may yield incorrect values when lateral runout of hub is measured (see below).