760 V6-2849cc 2.8L SOHC B28F (1983)
ADJUST PADS
The four outer pads on each side should be angled towards and just touching the glass. The two outer pads on each side should be placed near the clamps
but not so near that they move when the glass is pressed into position.
The four outer pads on each side are adjustable.
The four center pads are not adjustable.
PRESS GLASS INTO POSITION
Exercise extreme care when pressing the glass into position. Turn each of the clamp screws one turn. Next unscrew the clamps, first on one side and then
the other, a 1/4 turn. Wait about 30 seconds before tightening the screws again.
Turn the screws by less than a 1/4 of a turn when close to the installation measurement.
The outside of the glass should be 9.0 - 10.5mm (0.35" - 0.59") from the frame.
REMOVE FIXTURE
Break off outer part of glass support clips.
Install:
-
clips
-
trim mouldings
-
cowl top panel
-
rubber grommets
-
wiper arms