780 V6-2849cc 2.8L SOHC B280F (1987)
Note:
Measure resistance between screen and body as illustrated, not between screen and fuel pipe.
Resistance should be 0 ohm. If higher reading is obtained, remove aerial at body mounting point, scrape off paint around underside of hole and apply
rust inhibitor.
Reinstall aerial (tighten to 4 N-m) and check that resistance is now 0 ohm.
Reconnect aerial lead. Secure ferrite ring "package" to lead using third tie supplied with kit, using appropriate method as follows:
-
If car is equipped with electric aerial, secure rings to aerial tube
-
If car is equipped with ordinary aerial, secure rings to adjacent wiring harness.
In either case, ensure that "package" cannot rattle.
Reinstall plastic cover and carpet.
5-door 1982-1990 models
Remove rear interior light and rear roof liner panel.
Loosen top of D-post panel, lift and remove.
Undo aerial lead connector.
Thread ferrite rings onto aerial lead.