780 V6-2849cc 2.8L SOHC B280F (1987)
Control Module HVAC: Service and Repair
Electronic Climate Control Module
Programmer (Control Module) Removal
1. Remove:
-
panel under glove box
-
glove box
-
outer panel vent and air duct.
2. Remove:
-
air mixing shutter operating arm from programmer
-
connector at left side of programmen, separate splice connector
-
three-pin connector (not visible in illustration)
-
retaining clip from vacuum connection.
3. Remove
-
screws (three) securing programmer in climate unit
-
remove programmer.