850 T-5 L5-2.3L Turbo VIN 58 B5234T5 (1997)
Installing Thin Hoses
-
Connect the two thin hoses to the EVAP canister as follows:
-
The hose from the fuel tank has a small cast collar on it's rubber sleeve connector. This hose should be connected to the canister connector marked
"TANK".
-
The other hose, that goes to the canister purge (CP) valve, should be connected to the EVAP canister connector marked "PURGE".
Installing EVAP Canister
-
Locate the EVAP canister and screw into place. Check that the upper clamp has gripped the top edge of the EVAP canister properly.
-
Attach the large hose to the clip/holder mounted on the outside of the EVAP canister.
-
Check that the large hose is properly mounted so that it will not rattle when the fender liner has been installed.
Installing Fender Liner
-
Install fender liner. Use a new rivets.
-
Reinstall left front wheel.