850 T-5 L5-2.3L Turbo VIN 58 B5234T5 (1997)
Preparations
Raise the car.
The vibration damper must be installed on the viscous coupling housing mounting on the underbody.
2
Removing the viscous coupling housing
Install a transmission jack as a support under the viscous coupling housing.
Remove the bolt for the viscous coupling housing mounting (see the illustration).
Lower the viscous coupling housing and propeller shaft. Clean any dirt and under-body sealant from the mounting.
Use Cleaner H, P/N 1161436-9.
3
Drilling holes
Drill a 4.5 mm (11/64") hole.
Note! Shorten the drill bit to approximately 12-15 mm (1/2") to obtain the correct angle for drilling.