850 T-5 L5-2.3L Turbo VIN 58 B5234T5 (1997)
-
Install wiper motor. Make sure that hoses and leads do not get pinched.
-
Install wiper motor screws.
-
Connect wiper motor connector and install in clip as before.
-
Adjust position of cable duct so it runs between the bodywork and front end.
-
Refit control module box, inserting it in front under the bodywork plate section.
-
Install rear mounting screw.
-
Install connecting support to control module box rear air inlet.
-
Insert center section of control module box so control units fit into guide slots. Now push in until clip locks.
-
Install cover to control module box. Make sure clip locks.
-
Install upper mounting screw.
-
DLC (Data Link Connector).
CAUTION: Take great care to avoid damaging control modules or control module box. Check that upper and lower sections of control module box
are a tight fit and that clip locks properly.