850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
-
Lift subframe using previously installed tool 999 5517 and 5518.
-
Check that steering wheel joint does not get caught in body opening when lifting frame.
-
Lift rear edge of frame to half of tool's bolt length. Then repeat for front edge.
-
Lift frame until its bushings are only a few millimeters (fractions of an inch) from frame members in same order as above.
NOTE: It is important to lift the frame in the right order, otherwise the steering wheel column joint will get caught in the body opening.
[LE19]
-
Stan attaching frame on LH side. Position and apply a jack under the frame's LH side.
-
Install support bracket bolts loosely.
-
Remove tools 9995517 and 5518.
-
Install subframe bolts.
NOTE: Note washers on front bolts. Use new bolts (4 st M14). Grease bolt threads.
-
Tighten bolts to 105 Nm (77 ft.lb), then turn through 120°. Use angle gauge 951 2050.
-
Now tighten support bracket bolts to 50 Nm (37 ft.lb).
-
Transfer jack to RH side and repeat procedure as above.
Finishing work on raised car [LE20]