850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
Fuel Pressure: Testing and Inspection
FUEL PRESSURE AND RESIDUAL PRESSURE TESTING
Checking Vacuum Hose to Pressure Regulator
^
Remove throttle pulley cover.
^
Disconnect vacuum hose from pressure regulator.
^
Check for blockage by blowing through hose.
If hose is clear:
-
Connect pressure gauge.
If hose is blocked:
-
Check hose and connection at intake manifold.
-
Clean or replace as required.
Connect Pressure Gauge
^
Fit pressure gauge P/N 9995011 using union P/N 9989725 and adapter P/N 9995479.
^
Connect adapter to valve on fuel distribution manifold, with adapter in locked position (i.e. valve closed).
^
Turn pressure gauge cock towards adapter P/N 9995479.
^
Connect other gauge connection to fuel drainage unit P/N 9812270, P/N 9812273 and P/N 9812282.
^
Unlock adapter (i.e. valve open).
^
Continue with START FUEL PUMP section below.
Start Fuel Pump
^
Remove electrical distribution unit cover.
^
Remove fuel pump relay (position 103 in electrical distribution unit).
^
Connect jumper lead across relay base terminals 1 and 3.
^
Switch ignition ON. Fuel pump should start.
^
Continue with MEASUREMENT OF SYSTEM PRESSURE section below.