850 T-5R L5-2.3L Turbo VIN 58 B5234T5 (1995)
Support - Half Shaft/Short Shaft: Service and Repair
Special Tools
-
Standard shaft tool No. 999 1801, or equivalent
-
Ring tool No. 999 2853, or equivalent
-
Drift tool No. 999 5118, or equivalent
-
Press ring tool No. 999 5491, or equivalent
-
Drift tool No. 999 5318, or equivalent
-
Drift tool No. 999 5519, or equivalent
-
Refer to special tool section for additional tool information.
Universal Tool
-
Pliers tool No. 981 4215, Or Equivalent
Preparation
-
Removing/replacing driveshafts, see:
Axle Shaft Assembly, Constant Velocity Type, Removal steps 1 through 6. See: Axle Shaft/Service and Repair/Axle Shaft Assembly, Constant
Velocity Type/Removal
Axle Shaft Assembly, Constant Velocity Type, Installation steps 1 through 4. See: Axle Shaft/Service and Repair/Axle Shaft Assembly,
Constant Velocity Type/Installation
NOTE:
-
Unless stated otherwise, the Procedure for replacing the support bearing and cleaning the inboard universal joint is the same for both manual and
automatic cars.
-
The inboard universal joint can only be dismantled in automatic models.
Procedure
Driveshaft, manual models,
1. Exposing inboard universal joint
-
Remove clips from inboard boot (gaiter).
-
Slide boot (gaiter) off inboard universal joint.
2. Cleaning off grease from universal joint.
Mount driveshaft In vice with gap In circlip pointing upwards.