940 L4-2.3L SOHC VIN 88 B230F (1992)
Brake Pad: Service and Repair
Front
Front brake pads, replacement (two-piston caliper)
The procedure is applicable to Bendix (DBA) and Girling brake calipers on models to 1991 inclusive.
C1. Jack up and support front of car. Remove wheels
Mark wheel positions if locating studs are not fitted. Place support stands under jacking points.
C2. Remove lower guide sleeve/guide pin bolt
Girling caliper: Hold guide pin with 17 mm socket while removing bolt.
C3. Raise caliper and tie up with wire
Remove pads.
Note: Do not operate brake pedal while pads are removed.
Clean pad mating surfaces in caliper.