940 L4-2.3L SOHC VIN 88 B230F (1992)
Bridging System Relay
3.
Turn ignition OFF.
4.
To start fuel pump, remove the system relay (located in center console behind ash tray) and seat belt reminder relay.
5.
Connect a lead between terminals 30 and 87/2 and between 30 and 85 on relay base. The fuel pump should start operating. Fuel tank pump can be
heard by removing the tank cap. If fuel pump does not run, see FUEL PUMP(S).
Bridging Suppressor Relay
6.
Disconnect suppressor relay located in front of coolant expansion tank.
7.
Bridge terminals 3 and 4 of relay base.
8.
Check for the one terminal with current at cold start injector connector.
9.
Connect a test lead between that terminal and its connection at the injector.
10.
Connect a lead between ground and the other terminal at the injector. Injector will now start operating.
11.
Use a fuel resistant clear container to catch the fuel.
