Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


940 L4-2.3L SOHC VIN 88 B230F (1992)

Powertrain Management > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Engine Control Module: > 28910 > Dec > 93 > Ignition/Fuel Control Modules - Revised > Page 4140

Page 4
background image

Remove lead carefully to avoid damage to terminal.

To insulate ends of the grey-black and green-yellow leads, crimp splicing sleeves, p/n 956958-3, onto uncut ends.

Note:

Do not strip ends and ensure that sleeves are securely crimped in position. Replace protective cover over connector. Bend rubber protector back into
position and secure with new cable tie.

Compare part number on MFI control module in car with numbers in table.

Replace module if number does not agree with p/n specified in table.

Apply grease, p/n 1161417-9 into terminal sleeves of connector.

Reconnect connector to module.

Reinstall:

Powertrain Management > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Engine Control Module: > 28910 > Dec > 93 > Ignition/Fuel Control Modules - Revised > Page 4140

[PREV PAGE] [NEXT PAGE]