Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


940 L4-2.3L SOHC VIN 88 B230F (1992)

Powertrain Management > Relays and Modules - Powertrain Management > Relays and Modules - Ignition System > Ignition Control Module > Component Information > Technical Service Bulletins > All Other Service Bulletins for Ignition Control Module: > 2859 > May > 92 > Ignition and Fuel Injection Systems - Modifications > Page 4488

Page 3
background image

Remove grey/black (GR-SB) lead from position 32 in connector.

Cut lead 1.75" from connector entry as illustrated.

Remove green-yellow (GN-Y) lead from position 15 in connector. 

Cut lead 3.25" from connector entry as illustrated.

Remove green-red (GN-R) lead from position 14 in connector and insert in position 15

Caution! 
Remove lead carefully to avoid damage to terminal.

To insulate ends of the gray/black and green/yellow leads, crimp splicing sleeves, P/N 956958-3, onto uncut ends.
Note:
Do not strip ends and ensure that sleeves are securely crimped in position. Replace protective cover over connector. Bend rubber protector back into
position and secure with new cable tie.

Powertrain Management > Relays and Modules - Powertrain Management > Relays and Modules - Ignition System > Ignition Control Module > Component Information > Technical Service Bulletins > All Other Service Bulletins for Ignition Control Module: > 2859 > May > 92 > Ignition and Fuel Injection Systems - Modifications > Page 4488

[PREV PAGE] [NEXT PAGE]