Volvo Workshop Manuals
940 L4-2.3L SOHC VIN 88 B230F (1992)
Powertrain Management > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Crankshaft Position/Engine Speed Sensor <--> [Engine Speed Sensor] > Component Information > Technical Service Bulletins > RPM Sensor - Improved > Page 4584
Grease the connector (if this has not been done already)
Squeeze grease, P/N 1161417-9 into female contact directly from the tube.
Make sure that all the cavities in the housings are filled.
Do not fill the protective cover with grease.
Replace the connector
Make sure that the seal is firmly seated before replacing the connector.
Start the motor and let it run for about 1/2 minute.
Reset the diagnostic (OBD) system.
Claims may be submitted under the New Car Limited Warranty when a manufacturing defect is present using claim type: 01
RPM sensor replace
|[PREV PAGE] [NEXT PAGE]|