Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


940 L4-2.3L SOHC VIN 88 B230F (1992)

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Engine Control Module: > 2859 > May > 92 > Ignition and Fuel Injection Systems - Modifications > Page 778

Page 3
background image

Remove grey/black (GR-SB) lead from position 32 in connector.

Cut lead 1.75" from connector entry as illustrated.

Remove green-yellow (GN-Y) lead from position 15 in connector. 

Cut lead 3.25" from connector entry as illustrated.

Remove green-red (GN-R) lead from position 14 in connector and insert in position 15

Caution! 
Remove lead carefully to avoid damage to terminal.

To insulate ends of the gray/black and green/yellow leads, crimp splicing sleeves, P/N 956958-3, onto uncut ends.
Note:
Do not strip ends and ensure that sleeves are securely crimped in position. Replace protective cover over connector. Bend rubber protector back into
position and secure with new cable tie.

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Engine Control Module: > 2859 > May > 92 > Ignition and Fuel Injection Systems - Modifications > Page 778

[PREV PAGE] [NEXT PAGE]