Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


940 L4-2.3L SOHC VIN 88 B230F (1992)

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Ignition System > Ignition Control Module > Component Information > Technical Service Bulletins > All Other Service Bulletins for Ignition Control Module: > 2859 > May > 92 > Ignition and Fuel Injection Systems - Modifications > Page 1085

Page 5
background image

Control unit marked S101529102C (or-D) must not be replaced.

If control unit marking is other than the above, replace with unit marked S101529102C (or-D), P/N 3507696-7.

Apply grease, P/N 1161417-9 into terminal sleeves of connector.

Important! 
The control unit supply must be disconnected when removing or installing the unit, otherwise the unit may suffer damage.

Properly reinstall reinforcing plate and knee bolster.

Reconnect battery ground lead on completion of work.

Attach white label bearing text RE 92 to inside of fuel filler cover.

Clear fault codes (if any) in fuel and ignition control systems.

After test-driving car, display and correct new fault codes (if any) in fuel and ignition systems.

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Ignition System > Ignition Control Module > Component Information > Technical Service Bulletins > All Other Service Bulletins for Ignition Control Module: > 2859 > May > 92 > Ignition and Fuel Injection Systems - Modifications > Page 1085

[PREV PAGE] [NEXT PAGE]