Volvo Workshop Manuals
940 L4-2.3L SOHC VIN 88 B230F (1992)
Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Throttle Position Switch > Component Information > Technical Service Bulletins > Throttle Switch/Mechanism - Adjustment > Page 2246
D) Place a feeler gauge of thickness ( t ) (see table) at throttle pulley stop. Thickness will vary depending on engine type.
E) Turn mid-section of link until the lever leaves adjusting screw and throttle switch clicks. Turn link in opposite direction until return click is heard
F) Check lever clearance
Place feeler gauge of proper thickness (t) at throttle pulley stop.
- that 0.50 mm feeler gauge cannot be inserted between lever and adjusting screw.
If clearance is not between these limits, undo locknuts on link and repeat procedure from E on.
G) Remove feeler gauge at pulley stop when adjustment has been completed.
1.5 FINAL CHECK
Check that basic adjustment is OK by carrying out procedure 1.1.
2. CHECKING THROTTLE SWITCH
|[PREV PAGE] [NEXT PAGE]|