Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


940 L4-2.3L SOHC VIN 88 B230F (1992)

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Transmission Position Switch/Sensor, A/T > Component Information > Testing and Inspection > Bendix > Page 2261

Page 2
background image

Removing Protective Sleeve

5.

Remove connector protective sleeve and reinstall fuse #1 for testing.
CAUTION:^ Never check connections from the front. Connectors can get damaged and worsen the problem.

^ Check connections through the holes in the connector.
^ Connection pin numbers are printed on the connector side.

Checking Pin 30

6.

Put gear selector in N (neutral) position.

7.

Connect an ohmmeter between ECU connector pins 30 and ground.

Reading: 0 ohm

8.

Put gear selector in D (drive) position.

Reading: infinite (0 ohm on vehicles with manual transmission)

9.

If switch fails the test, check wiring and connectors. If no fault found in wiring, replace gear selector switch.

10.

Disconnect the test equipment. Remove the #1 fuse and reconnect the ECU and all other connectors, install the kick panel and glove compartment.
Ensure that the rubber seal in the ECU connector is installed before it is connected to the unit. 

11.

Reinstall the #1 fuse.

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Computers and Control Systems > Transmission Position Switch/Sensor, A/T > Component Information > Testing and Inspection > Bendix > Page 2261

[PREV PAGE] [NEXT PAGE]