Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


940 L4-2.3L SOHC VIN 88 B230F (1992)

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Fuel Delivery and Air Induction > Throttle Position Switch > Component Information > Technical Service Bulletins > Throttle Switch/Mechanism - Adjustment > Page 2360

Page 6
background image

Open throttle slightly, insert feeler gauge between lever and adjusting screw, and check as follows:

With 0.25 mm gauge, click should not be heard from switch when throttle is closed.

With 0.15 mm gauge, click should be heard from switch when throttle is closed.

- Adjust throttle mechanism (see item 1.4).

Note:

The following operations describe standard operations which may be required when adjusting throttle housing and throttle mechanism.

Basic Adjustment of Throttle Housing and Mechanism

1. BASIC ADJUSTMENT OF THROTTLE HOUSING AND MECHANISM

1.1) CHECKING NEED FOR ADJUSTMENT 

Run engine up to working temperature.

Connect accurate tachometer to engine. Allow engine to idle.

Clamp idling valve (CIS) hose with pliers (arrow).

If engine stops or speed falls below 470 r/min, in, basic adjustment is acceptable.

Also check throttle switch as described (if not already carried out).

Proceed to next step.

1.2) CENTERING THROTTLE PLATE

Remove throttle switch from throttle housing.

Sensors and Switches > Sensors and Switches - Powertrain Management > Sensors and Switches - Fuel Delivery and Air Induction > Throttle Position Switch > Component Information > Technical Service Bulletins > Throttle Switch/Mechanism - Adjustment > Page 2360

[PREV PAGE] [NEXT PAGE]