940 L4-2.3L SOHC VIN 88 B230F (1992)
Remove:
-
trim at top of windshield
-
trim at A-posts. Use flat blade. Insert blade under trim. Feel for centre tab on clip.
Press blade downward towards windshield.
-
clips from top edge and A-posts
-
support clips (two) at bottom of windshield
Place masking tape on windshield pillars and wing edges to protect paintwork from damage by cutting wire.
Thread piano wire from inside to outside through PUR bead.
Use needle-nosed pliers to pull wire from outside. Attach wire to handle on outside and to counterhold inside car.
Two-person operation
Press counterhold firmly as far as possible from point of cutting at inside of windshield.
Exert smooth, gentle pulling action on handle outside.
Pause and move counterhold gradually while maintaining tension on wire.
"Saw" around corners.
Take care to avoid damage to interior fittings and paintwork.
Attach suction cups to windshield and lift out glass.
PUR bead on body may be smoothed off with chisel as required. Always leave pant of the bead, with a height of approx. 1 mm.
