940 L4-2.3L SOHC VIN 88 B230F (1992)
Ensure that spacers on A-posts and at top of windshield are intact and seated firmly in position.
Replace, as required:
3518259 (dark blue) at bottom of A-posts
3518244 (black) in other positions
Spacers on A-posts are located as illustrated.
Top edge of flange is provided with openings for locating clips.
Install windscreen
Apply PUR adhesive to windshield.
Note:
Two-component PUR adhesive must be used in all cases when car is equipped with dual bag SRS.
Use gloves and ensure that ventilation is adequate.
Hold spray at right-angles to glass with guide pin outside edge of glass.
Lift windshield into position.
Windshield must be placed in position within 10 minutes if two-component adhesive is used.
Press windshield firmly into position by hand. Gap at top and at each side should be equal.
Press down windshield to bear against spacers and spacing tape.
Use strips of tape to secure windshield to roof.
