940 L4-2320cc 2.3L DOHC VIN 89 B234F FI (1991)
Place 0-rings in position
Place 0-rings in grooves around housing oilways.
Fix 0-rings in position by packing grooves with grease and lubricate housing joint faces with thin coating of grease.
Install balance shaft housing
Ensure housing is replaced evenly on front and rear mountings. Max. permissible deviation between mounting faces with reference to block is 1 mm
(0.04 in).
Tighten bolts alternately in diagonal pattern. Tighten each bolt by max. 1/2 turn at a time.
Tighten bolts to 20 Nm (15 ft.lb).
Slacken and retighten to 10 Nm (7.5 ft.lb) and through a further 90°.
NOTE: Check that shaft does not seize in housing during tightening procedure.
Tighten bolted joint between housing halves
Tighten to 5 Nm (6 ft.lb).
Install drive pulley
Use counterhold 5362.
NOTE: Slot in pulley hub must be aligned with guide pin on shaft end. Shallower side of pulley must face inwards.