940 SE L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1991)
Note!
Before removing the seat wiring from the car's main wiring harness, the seat should be as far to the rear as possible and the cushion at the front and
rear edge as high as possible.
Remove Seat from Floor
Remove the seat from the floor according to the method shown in the Service Manual and place it with the backrest on the rear seat.
Note!
The seat belt does not need to be removed.
Position a box under the seat rails so that the underside of the seat is accessible.
Make sure that the seat rails do not scratch any interior surfaces.
Inspecting Cables
Ensure wiring is in good condition and is correctly routed.
Excessively worn cables must be replaced.
The cable must be clamped adequately so that no new damage can occur.
Protection for Seat Belt Buckle Cable
Protection for Seat Belt Buckle Cable
Pictures seen from the center:
Use rubber plug 941269-3.
Make a small hole and a cut in the rubber plug. Install rubber plug on cable.