940 SE L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1991)
-
Remove all sockets.
-
Remove rheostat. See: Service and Repair
-
Carefully pry off connector holders with a screwdriver.
-
Remove all screws and nuts retaining circuit card.
Note: All instruments come free at the same time.
-
Remove circuit card.
-
Fit new unit.
-
Reassemble in reverse order. Tighten all screws well.
-
Test.
Yazaki circuit card, replacement .................................................................................................................................................................................. S13
760/960 1988-1994
-
Check that there is no corrosion between screws and circuit card, as per S11.
-
Remove circuit card holders in upper connector.
-
Remove all bulb sockets.
-
Remove rheostat. See: Service and Repair
-
Carefully pry off connector holders with a screwdriver.
-
Remove all screws retaining circuit card.
Note: All instruments come free at the same time.
-
Remove circuit card.
-
Fit new unit.
-
Reassemble in reverse order. Tighten all screws well.
-
Test.
Yazaki circuit card, replacement .................................................................................................................................................................................. S14
940/960 1995-
-
Check that there is no corrosion between screws and circuit card, as per S11.
-
Remove backplate from housing by removing screws round the edge as shown.
-
Remove all bulb holders.
-
Remove rheostat. See: Service and Repair