940 SE L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1991)
Reassembly
NOTE: Do not turn the wheel, the contact reel locking pin will sheer off.
-
Replace casings.
-
Thread lead from contact reel through the hole in the wheel.
-
Position the wheel such that the contact reel locking pin is in the center of the hole in steering wheel.
-
Refit bolt holding steering wheel finger tight.
-
Remove screw in plastic strip from pin and place in park position in steering wheel.
-
Tighten steering wheel bolt to 33 Nm (24.3 ft.lb).
-
Rest lower part of air bag assembly on steering wheel.
-
Plug in connector. Raise assembly and secure with screws.
Torque: 8 Nm (5.9 ft.lb).
-
Check that lead is free and not trapped.
-
Check that air bag is firmly attached.
-
Reconnect battery negative lead.