940 SE L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1991)
Checking Terminal Pins
6.
Check that terminal contacts have been pushed down evenly in connector.
7.
If any connectors have been pushed down to far, poor connection may result.
Checking Pin 6
8.
Turn ignition ON.
9.
Connect a voltmeter between pin 6 (blue) at ECU connector and ground (checking ignition switch power supply).
Reading: approx. 12 volts
10.
If not, check wiring and connectors. If no fault found, replace ignition switch and retest.
Checking Pins 6 And 20
11.
Connect the voltmeter between pin 6 (blue) and pin 20 (brown).
Reading: approx. 12 volts
12.
If not, check wiring (pin 20 to ground) and fix as necessary.
13.
Turn ignition OFF.
Checking Pin 3