940 SE L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1991)
Throttle Position Switch: Adjustments
THROTTLE POSITION SWITCH ADJUSTMENT
Adjusting the Throttle Position Switch
^
Start by turning the Throttle Position (TP) Switch clockwise as shown by the arrow (A) until it stops.
^
Then turn the TP switch counter-clockwise as shown in the illustration by the arrow (B) until a "click" is heard, and then continue to turn until it
stops, but no further.
^
The throttle must not start to open, so hold it closed with a finger on the throttle disc. Keeping the TP switch in the position tighten the screws on
the switch.
Checking
^
Open the throttle and check the gap between the throttle lever and adjustment screw with a feeler gauge.
^
With a 0.45 mm feeler gauge there should be no click from the idle switch when the throttle is closed.
^
With a 0.15 mm feeler gauge there should be a click from the idle switch when the throttle is closed.
^
Connect TP switch connector.