940 SE L4-2320cc 2.3L SOHC Turbo VIN 87 B230FT (1991)
Throttle Valve Cable (Kickdown Cable): Service and Repair
Removal
Cable To Thrtle Pulley Connection
1. Disconnect cable from throttle pulley.
-
Pull cable slightly out of sleeve in engine compartment.
-
Cut off cable between stop and cable tensioner.
-
Remove cut section from throttle pulley.
-
Remove cable tensioner and sleeve from mounting bracket.
2. Drain transmission fluid by removing drain plug.
-
Units without drain plug, disconnect filler tube from sump.
-
Remove sump and gasket.
WARNING: Fluid may be extremely hot if car has recently been driven.
Cable In Gearbox
3. Disconnect cable from gearbox. Use snipe-nose pliers to pull out a loop of cable and jam throttle cam with a screwdriver.
4. Disconnect cable from throttle cam. Clean outside of gearbox around cable sleeve and remove sleeve.