C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
-
the connector for the front micro-switch. Move the connector out of the way.
NOTE: Check that the locking arm is in the same position throughout the operation.
-
Pull out the wire through the front cross member and point the wire forwards.
-
Remove the drive wire secured with a spline joint.
-
Replace the drive wire.
Installing the drive wire for the front lock
NOTE: Check that the locking arm is in the same position throughout the operation.
-
the drive wire
-
use new tie straps for the wire and wiring
-
the connector for the front and rear micro-switches
-
the drive wire in the locking
-
the 2 nuts for the front lock motor.
-
Test the function of the drive wires.
-
Install the cover at the front edge of the front cross member.
-
Carefully fold back the textile outer roof and secure it at the front cross member.
-
Install the cover for the front lock motor in the convertible top.
Removing drive wires for the cover plate lock