C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
-
That there is no dirt in the master cylinder connections and that the packing box is intact.
Install:
-
Master cylinder and EBD pressure sensor. Use new nuts. Tighten to 25 Nm (18.4 ft.lb).
Remove:
-
Plugs from brake pipe and connect brake pipe. Tighten to 14 Nm (10.3 ft.lb).
Connect:
-
Connector to EBD sensor.
-
Brake fluid reservoir. Brake fluid reservoir, replacement and cleaning.
Finishing
-
Bleed braking system as per Brake Bleeding. Then continue as per instructions below.
-
Bleed clutch on cars with manual transmission.
Clean off any brake fluid spillages with lukewarm water and car-wash shampoo.
Pressure testing the braking system