C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
connection.
To ensure a good contact the soldering point must be free from dirt, oxidized metal, grease, paint etc.
Note! Note! Avoid soldering connections that carry a high power load.
Soldered connection quality
Choice of solder wire, flux and soldering tool as well as the location and method used affect the overall quality of a soldered connection.
Ensure that solder does not creep too far up the cable when soldering a terminal on to a cable, as there is a risk the cable can become brittle and break.
Soldering tool
There are different types of soldering tool. Usually a soldering iron with temperature control is used so that the temperature created on the soldering iron
tip can be adjusted.
Soldering wire
It is important to use soldering wire with a high quality non-corrosive flux. Use 50-50 or 60-40 rosin core solder.
Do NOT use acid flux solder (e.g. plumbing solder) as this will cause oxidation.
When to solder
If a terminal has been crimped using a tool not intended for terminal crimping then the cable terminal must be soldered.
To avoid soldering
Caution! Soldering cable terminals can be avoided by always making a point of using only Volvo special tools for terminal crimping or other
tool recommended by Volvo.
See Repair kit, p/n 9814235 See: Tools and Equipment/Repair Kit, P/N 9814235/Repair Kit, P/N 9814235 Cable Terminals box, p/n 9814232 See:
Tools and Equipment/Repair Kit, P/N 9814235/Cable Terminals Box, P/N 9814232 Cable Terminals Kit, p/n 9814233 See: Tools and
Equipment/Repair Kit, P/N 9814235/Cable Terminals Kit, P/N 9814233 Cable Terminals Kit, p/n 9814234 See: Tools and Equipment/Repair Kit, P/N
9814235/Cable Terminals Kit, P/N 9814234 Special tools, in repair kit p/n 9814235 See: Tools and Equipment/Repair Kit, P/N 9814235/Special Tools,
In Repair Kit P/N 9814235 Other tools See: Tools and Equipment/Other Tools.
Cutting and Checking a Cable
Cutting and checking a cable
Cutting a cable