C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Accelerator Pedal: Procedures
Replacing The Accelerator Pedal Module
Removing the accelerator pedal module
Remove the stop lug in the connector on the pedal module.
Disconnect the pedal module connector.
Remove the pedal module.
Installing the accelerator pedal module
Install the pedal module. Tighten to 10 Nm.
Connect the module connector.
Install the stop lug in the connector on the pedal module.
NOTE: After replacing the accelerator pedal (AP) position sensor, the engine must be run at idling speed for a couple of minutes before normal
operation can resume. The is because the system adapts the new accelerator pedal (AP) position sensor to compensate for any differences between the
components. If this is not carried out there will be a dead point in the accelerator pedal (AP) position sensor.
