C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Press up the rear edge of the subframe. Use a mobile jack
-
At the same time align the mounting screws for the steering gear in the subframe.
Install the brackets for the sub-frame
-
Install new screws (M14) for the sub-frame loosely. Transfer the mobile jack to the front edge of the frame. Replace the front screws for the
sub-frame. Do not tighten yet.
-
First tighten the screws on the left-hand side of the sub-frame. Tighten to 105 Nm. Angle tighten to 120 degree. Then tighten the right-hand side
to the same values as the left side.
-
Tighten the bracket screws. Tighten to 50 Nm.
Tighten:
-
the steering gear. Tighten to 50 Nm. Use new nuts
-
the brackets for the oil pipes at the front and rear edges of the sub-frame.
Install the splashguard under the engine (early version)