C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
Mark up the position of the right-hand transverse arm mounting in relation to the hole (2) in the left-hand trailing arm
Make a punch mark in the mounting at the edge of the hole.
Remove the other screw from the mounting.
Note! It is very important that markings are correctly made. If not the rear wheel toe-in will be incorrect.
Remove:
-
the mounting screws for the anti-roll bar
-
the anti-roll bar.
Installation
Note! To ensure that there is no exhaust leakage, see: Flanged joint, assembling See: Engine, Cooling and Exhaust/Exhaust System/Exhaust
Pipe/Service and Repair.
Install the new anti-roll bar
1. Install the screws using new nuts 2.3. Use a new screw and nut
Do not tighten the screws yet.
Install the transverse arm mounting on the trailing arm. Use new screws and nuts
