C70 L5-2.4L Turbo VIN 63 B5244T7 (2003)
-
the nut, lock washer and rubber seal from the gear-shift position sensor.
Remove the nut for the cable duct. Lift the cable duct to one side.
Remove the two screws from the gear position sensor.
Carefully lift the sensor off the gear shift linkage rod.
Removing the connector from the transmission
Disassembling the connector on the transmission
Separate the cable clamps. Disconnect the connector from the transmission.
Remove the sockets from the connector casing.
Remove the rubber seal from the connector.
Insert a screwdriver between the casing and socket. Press in the catch. At the same time, slide the sockets out of the casing.
Detach the base for the gear-shift position sensor (9-pin) from other bases.
Remove the gear position sensor.
Assembling the connector