C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
always start by heating the plastic to at least 40°C (104°F) to remove chemical substances which otherwise affect the end result.
If necessary align the damage first.
Clean the surface
Clean the surface with soap and water. Dry or blow dry.
Then clean with 3M 8884 E adhesive remover to remove grease, oil, tar, silicon etc.
Note! Isopropyl alcohol or similar is used for ABS plastics.
Sand surface
Sand the surface on the front and reverse so that the bodywork will adhere. If the damage has gone through bevel the edges to V shape
Scratches are only filled.
Blow clean and dry off the surface
Blow clean and dry off the surface.
Then spray a thin coat of 3M 5907 PAP and allow to dry.
If necessary secure the damaged area using a soldering iron or bonding adhesive.
Tape the damage
