C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
-
Disconnect the gray 14-pin connector from the control module
-
Cut off the four cable clamps holding the cable to the motor.
-
Pull cable out and remove motor.
-
Mark up the pin positions in the gray 14-pin connector B.
-
Press out the pin for the motor from the connector. Use terminal removal tool 951 2631 Terminal removal tool See: Tools and Equipment/951
2631 Terminal Removal Tool.
-
Pull the motor cables backward through the cable harness.
Reinstalling
Reinstall in reverse order.
-
Attach the cable as earlier using four cable clamps.
-
Leave slack to off-load the cable at the backrest angle (especially import on the right seat which can be folded forward).
-
When installing the impact protection: check that the impact protection is not contacting the SIPS airbag's gas generator.
SIPS airbag, removing the safety device
Remove the transport safety device from the sensor module and return it to its storage place on the inside of the control panel.
