C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
Install:
-
strip in upper rear corner by pressing strip on to flange. Continue around entire door opening.
Note! Strip must start right inside the corner to ensure a good fit is maintained.
-
front and rear door sill mouldings.
Check that a good fit is maintained.
Gently tap around door opening with a rubber hammer or similar so that sealing strip seats correctly.
Adjust strip using a pressure tool 981 4071 STRAIGHTENING TOOL See: Tools and Equipment/981 4071 Straightening Tool.
Rear part of door strip must fit with rear side window inner strip.
Distance between edge and strip (A)should be approximately 9mm (0.35") and (B) approximately 7mm.
Note! Make sure there is a straight line along the body.
Caution! It is important that pressure is applied to the strip to ensure the tape makes full contact with the body.