C70 Coupe L5-2.3L Turbo VIN 53 B5234T3 (2001)
Note! Both strip and vehicle should be at room temperature.
Note! The surface to which the strip is to be glued must first be cleaned free from dirt and grease.
Remove any remaining adhesive or tape using diluted isopropyl. One part of isopropyl should be mixed with one part of water for best result.
Warning! Avoid skin contact, use protective gloves and protective goggles. Allow for adequate ventilation.
Mask with 7 or 9mm (0.27"-0.35") masking tape around window opening as shown in figure.
Masking should be 7-9mm (0.27"-0.35") from edge (C), see figure.
Sand surface where strip was, using 1000- or 1200 grain sand-paper, as shown by shaded part of figure.
Clean dust from surface with diluted isopropyl. One part of isopropyl should be mixed with one part of water for best result.
Warning! Avoid skin contact, use protective gloves and protective goggles. Allow for adequate ventilation.
Installing rear side window outer strip
